mojosilikon.blogg.se - Wbox ip camera utility

Wbox ip camera utility how to#

Press RESET about 10s when the camera is powering on or rebooting.Īdvidia OEMs multiple manufacturers with different methods, including ACTi, Dahua, and Hikvision.

This procedure is identical to Hikvision, the OEM of WBox IP Cameras. The unit will start up with factory default settings

Keep holding the reset button depressed for around 6 seconds, release the reset button.

While continuing to hold the reset button depressed, reconnect the power cable.

Using a suitable pointed object, press and continue to hold the Reset Button depressed.

Switch off the IP camera by disconnecting the power cable.

Press and hold RESET for 10s when the camera is powering on or rebooting to restore the default settings, including the user name, password, IP address, port No., etc.

This procedure is the same as Hikvision’s own.Press the Reset button, and hold it for 2 seconds while the device is in use.

Exposed locations are notably less secure than others, as they allow the camera to be reset without disturbing it, which could effectively take it offline.ģxLogic has two different series with different reset methods: For ease of access, some reset buttons are located at the end of the whip or exposed on the exterior of the camera. For added security, some reset buttons may be located under the dome bubble or an access panel. There are a few common reset button locations, shown below.

Where manufacturers have multiple lines/OEMs/methods, we have made notes in each section.

Wbox ip camera utility how to#

In this article, we have listed factory default procedures for 30 manufacturers as a quick reference to help reduce this confusion and simplify the reset procedure.īelow, we list how to default each manufacturer using the physical reset button. Most of the IP cameras have a reset button, but it’s not always clear what these buttons do, where are they located, how long they need to be held pressed, what settings they actually restore, etc.